Fuel Injector Tester (ECM-A6L)

Product Specifications/Features:

ECCOM Fuel Injector tester & Cleaner mainly apply to fuel injector testing, cleaning and quality analyze. The functions as following:
To test and analyze the injecting state.
To test the injector dribbling.
To test the injecting angle and atomizing.
To test the injecting volume.
To test the injector uniformity.
To test the physical and chemical cleaning of the blocked or trouble injector, ultrasonic cleaning, test cleaning and on-vehicle cleaning.
To test the open and close injecting pressure of the injector.

Can clean the engine without dismantling (choose matched connector).
Can operate the auto static testdynamic test and selective test with the injecting dribblinganglesatomizationuniformity of one or more(1-6) injectors, can simulate any state of the vehicle to observe the complete process of injectors.
Can operate automaticallyreverselyand ultrasonic cleaning with one or more injectors at different
State, such as high resistorlow resistorelectric voltage and electric current.

Can test by count mode and timing mode, also have backlight, can observe the injectors clearly.
If use new type injector, just need choose the matched connector and replace the O-ring.
It adopts to united design of microcomputer skill and intelligent engine, and suppose driving power and specified injecting protection system, ensure to operate the test and clean at any mode such as high resistorlow resistorelectric voltage and electric current.
Have powerfulsafe and time ultrasonic cleaning system.
It uses environmental protective and safe test fluid and cleaning detergent, accords with Montreal Agreement, innocuouswith no peculiar smellnon-volatile and can be reclaimed repeatedly and effective, it's innocuous with the operators.

Technical Parameter:
Dimensions: 630mm × 600mm × 615mm
Weight: 32kg
Power: 85-132VAC/170-264VAC 47-63Hz
Fuel tank capacity: 2.5L
Test tube capacity: 120CC
Ultrasonic wave frequency: 38-39kHz
Ultrasonic wave power: 100W
Rotate speed: 0-9975r/min, step: 25r/min
Pulse width: 0-30ms, step: 0.1ms
Count: 0-9975r, step: 25r
Time: 0-9975S, step: 5S
System pressure: 0-6.2kg/cm2 (variable regulated)
System flow: 4L/min
Test cylinder: 6 (max)